13
Important notes before commissioning:
-
Please read the complete instructions before you start installing the thermostat
-
The thermostat must be installed by a qualified person
-
Use the thermostat only as described in these instructions
-
Always disconnect the power supply during installation work
Security:
When handling products that are supplied with electrical voltage, the applicable VDE regulations must be
observed, in particular VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711 and VDE 0860.
- Before opening the unit, make sure that it is de-energised.
- Tools may only be used on the unit if it has been disconnected from the power supply and any residual
electrical charges stored in components have been discharged beforehand.
- Live cables or lines to which the unit is connected must always be inspected for insulation faults or
breaks.
- If a fault is detected in the supply line, the unit must be taken out of operation immediately until the
defective line has been replaced.
If it is not clear from these instructions for the non-commercial end user which electrical characteristic
values apply to the unit, how external wiring is to be carried out, or which external components or
additional devices may be connected and which connection values these external components may have, a
specialist must always be consulted for information. Before commissioning the unit, it must be checked
whether this unit is suitable for the intended application!
In case of doubt, it is essential to consult specialists, experts or the manufacturers of the assemblies used!
Please note that operating and connection errors are beyond our control. Understandably, we cannot
accept any liability for damage resulting from this.
Unit dimensions