5
MI-Flues System 7
Vitreous Enamelled Stove Pipe
COMPONENTS
Increasing Adaptor
Designed to enable three diameters of System 7
pipe to be stepped up one diameter as appropriate.
It increases the diameter from 100mm to 125mm,
125mm to 150mm and 150mm to 175mm.
Rosette Plates
A rosette plate is used for aesthetic purposes to
improve the finish of a flue as it penetrates a wall.
Available in diameters from 100 mm to 200mm.
Rosette plates are available in 90° and 45°
angles. They are also available in split form for retro
fitting. Each rosette plate comes individually
packaged. The pack contains one plate, two half
plates in the case of the split rosette, plugs and
screws.
To install, fit the plate/plates around the flue pipe and
secure to a non combustible wall using the fixings
provided.
Adjustable Wall Bracket
A wall bracket provides lateral support to a chimney
run. It is not a load bearing support. Available in
various diameters— Wall bracket length can be
adjusted from 50mm to 250mm by cutting extended
bar.
Brackets are supplied with a stainless steel band and
galvanised stem as shown.
Brackets are not available in a vitreous enamel finish.
They can however be sprayed using a suitable enamel
paint which is available from your local merchant.
Product Dia.
(A)
(B) (C)
Sys. 7
100 125 155
Sys. 7
125 150 155
Sys. 7
150 175 155
Product Dia.
(A)
(B) (C)
Sys. 7
100 207 207
Sys. 7
125 230 230
Sys. 7
150 254 254
Sys. 7
175 281 281
Sys. 7
200 307 307
45° Rosette Plate
90° Rosette Plate
Coloured finish access door
Start Off Adaptor
This is used to connect an appliance to a System 7
pipe. It is available in 125mm and 150mm.
Product Dia.
(A)
(B)
Sys. 7
115
35
Sys. 7
140
35
Product Dia.
(A)
(B) (C)
Sys. 7
100 207 250
Sys. 7
125 230 284
Sys. 7
150 254 318
Sys. 7
175 281 356
Sys. 7
200 305 392
To install Mi-Flues System 7 door (as shown below),
firstly remove original door by opening the screws with
a suitable sized Allen key. Ensure surface of pipe is
clean and smooth before fitting new door. To fit the
new door, mate the gasket paper up with the inner face
of the door and pierce two holes to allow for the fitting
of the new screws. While firmly pushing the door
against the pipe in order to maintain a good seal, tight-
en the two screws, fastening the door to the pipe.
Mi-Flues System 7 door comes complete with the
following components: 1x Vitreous enamelled door and
1x Gasket Paper
Mi-Flues can supply a coloured
finished door (on request) as an
alternative to the standard steel finish.
Coloured finish door plus Rosette plate
