MHS Boilers XenoROL XR40, Installation, Operation & Maintenance Manual, Page: 27 / 84

XenoROL®
27
SUBASSEMBLY INSTALLATION
DRIVES
On drive beds under 24" wide, right angle drive
motors will protrude outside the conveyor frame.
The narrower the conveyor, the greater the
protrusion. Make sure the drive is located where the
motor will not cause interference. If there is a
problem, an alternate suitable location may need to
be found or use the optional low profile drive.
CURVES
Curves are installed the same as straight sections.
In addition to end supports, 90 degree curves should
have a support in the center of the outside frame
channel. Curve center leg supports are available. If
a curve is joined by inclined XenoROL
®
, a universal
is required on a 1' -0" minimum length straight bed
installed between the curve and the incline.
WARNING
U-joints used in curves can be dangerous. The
curve line-shaft guards and U-joint covers are
installed at the factory and must always be in
place when operating conveyor.
90480006rev092010