MGI ZIP X1, User Manual

Page: 8 / 13

MGI Zip X1
User Manual
15 14
Step 2:
There are two silver thumb screws located on either side
of the front wheel. Adjusting these screws will help straighten the
alignment by correcting the Zip X1 to track more to the left or the
right.
Roll the left or right hand side silver thumb screw UP to straighten
the Zip X1 more to the LEFT.
Roll the left or right hand side silver thumb screw DOWN to
straighten the Zip X1 more to the RIGHT.
You can roll the screws simultaneously or individual to achieve the
desired alignment.
Step 3: Once alignment is set, turn the lever and tighten. Then
close the lever.
TIP: When adjusting the front wheel and testing the alignment,
ensure the Zip X1 is run on a flat, smooth surface like a carpark.
8.0 Warranty
8.1 Warranty Policy
The MGI Zip X1 is covered by a limited 2 year manufacturer’s
warranty from the date of purchase. Duration of this warranty is:
– 2 years on parts*
– 2 years on Lithium batteries and chargers
*MGI or an authorised service centre will repair or replace any
parts found to be defective in materials or workmanship under
normal use provided that:
1. The MGI Zip X1 has been properly used, maintained and
regularly serviced [see section 10.5]
2. The replacement or repair is performed by an authorised MGI
service centre or the owner with MGI approval.
3. The Zip X1 has been registered online.
8.2 Warranty Exclusions
The following events will void warranty:
• Any alteration performed by non-authorised people
or companies.
• Fitting of parts or accessories not recommended by MGI.
• Any damage caused by continued operation of the
Zip X1 after it is known to be defective.
• Damage to seat and/or seat support bracket.
• Damage caused by ingress of water into motor/gearbox
and other major components.
• Damage caused by the Zip X1 going into bunkers and other
course hazards.
• All implied warranties [save those preserved by statute] are
excluded. Liability for consequential damages under any and
all warranties are excluded to the extent exclusion is permitted
by law.
8.3 Parts Installed During Warranty
Warranty coverage for components installed during a motorised
Zip X1’s warranty period shall consist of the duration of the Zip X1’s
warranty period, provided the warranty installation is performed
by MGI, an authorised service centre or the Zip X1 owner on
approval. Replacement of parts under warranty will not extend
the warranty of the Zip X1 or parts.
Thumb Screw
Tighten