Perf
orming a workflow
24
Workflow
Prepare for a workflow
Initialize the device
Log in to the control software
Start a workflow
Post-process
Samples in the sample tubes might cause cross contamination through
contact with the skin, eyes, and mucosa. Follow the safety standards of your
laboratory and wear protective equipment (such as laboratory coat, and
disposable bouffant cap, protective glasses, mask, gloves, and shoe covers).
Logging in to the control software
You can start an experiment only after you log in to the control software.
Perform the following steps:
1. Power on the device, and then power on the computer.
2. Log in to the computer with the password that is provided by the
technical support.
3. Wait about 3 minutes, on the desktop, double-click the control
software icon to launch the software.
4. Set the mode to
Real
.
5. Select
User
in the
Username
list, use the on-screen keyboard to
input the password that is provided by the technical support, and
click
Login
.
Summary of Contents for MGISTP-3000
