MG Energy Systems B.V. | Foeke Sjoerdswei 3 | 8914 BH Leeuwarden | The Netherlands
+31 (0)58 750 89 47 | [email protected] | www.mgenergysystems.eu
Innovation
in energy storage
4.
Connectors in place.
Un-mating of the connector CAN-bus connectors is done by the above steps in opposite order.
8.3.2
External power supply connection
To connect external power to the Monitor, refer to the following steps:
1.
Match alignment of the pins on both the connector and the cable.
2.
Lock the connector by rotating the locking nut clockwise. Hand-tightened will be sufficient,
do not use tooling to tighten.
3.
Connector in place.
WARNING:
Make sure the voltage applied to the external power connector is in the range
listed in the technical specifications (see section 10).
