31
Gate Out
– this jack outputs a gate signal being
generated
by
Dominion
I's
keyboard
or
its
arpeggiator/sequencer. It may be used to trigger an
external envelope.
FM In
– an external signal applied to this input will replace
VCO3
as the source of frequency modulation for
oscillators 1 and 2 (see page 10). The settings for
Select
and
Freq Mod
will remain valid. Inserting a cable here will
interrupt the internal FM-connection.
Sync In
– an external signal applied to this input will
replace
VCO1
as the sync reference (see page 9). The
setting for the
Sync
selector will remain valid. Inserting a
cable here will interrupt the internal sync-connection.
Ext In
– use this input to feed an audio signal into the
Mixer
, replacing the noise generator (see page 11). The
corresponding level is set using the
Mixer
control
Noise/Ext
. The internal noise generator is being
deactivated as soon as a cable is inserted into this jack.
CV VCF
– this CV-input allows modulation of the filter
frequency with a control voltage. This modulation is
added to existing modulation signals of the envelope,
LFO and ribbon.
CV VCA
– this CV-input addresses the VCA by a control
voltage. This signal may open the
VCA
even if no note is
being played on the keyboard.
VCF Out
– this jack outputs the signal after passing
through the filter section (but prior to the
VCA
). This signal
may be fed into a modular system for example.
Mix Out
– this jack outputs the oscillators' signal after the
Mixer
stage (but prior to the
VCF
and
VCA
). This signal
may be fed into a modular system for example.
Summary of Contents for DOMINION 1
Page 1: ...Operating Manual...
