Meyra 1.254, Operating Manual

Page: 21 / 52

3
1
3
5
21
PRE-OPERATION CHECKS
Before starting to drive, the following should
be checked:
1. The battery charging condition (1)
2. The preselected setting of the pre-se-
lectable final speed (5).
☞
Therefore observe chapter Preselect-
ed final speed on page 18.
Battery charging condition
After activation the battery gauge (1) shows
the battery charging condition. The needle
of the battery gauge moves left to the be-
ginning of the red display when the battery
capacity lessens.
☞
The displayed value depends on the
surrounding temperature, the age of
the battery as well as their type of strain
and is therefore to be observed with
limitations.
☞
If the red light segment of the battery
gauge is blinking, the batteries should
be charged immediately.
☞
Therefore observe chapter
Fault correc-
tion
on page 36.
☞
View chapter
Battery voltage
on
page 17.
Recharging batteries
Solely use a charger that corresponds to
the type of battery!
The batteries should be charged right after
the daily use of the Scooter so that the com-
plete driving performance is available the
next day.
Every battery is subject to a regular "self-dis-
charge". The batteries should be recharged
once a month when the Scooter is not used
for a long period of time. The Scooter will
then always stay ready for use.
☞
Charge preferably during the night. A
complete charge of the batteries re-
quires about 8 hours.
Batteries should only be charged with a bat-
tery charger that is suitable for the type and
rating of this battery. The guarantee is only
preserved to its full extent when the sup-
plied and recommended battery charger is
used.
☞
Avoid spark build up through electrical
static (for example caused by synthetic
floor covers).
☞
Observe the operating manual of the
charger.