Once the body mounts have been adjusted with the hammer,
the upper angled flange should be parallel to the fiberglass as
shown.
When satisfied with the fit, have a helper hold the body in place
while holes are drilled for the body mounting hardware. Using
the original body mounting holes as guides, drill eight 5/16” holes
on each side of the body from the underside.
If
a pan of different manufacture (such as the Berrien chassis) is
being used, drill one hole 1- ½ inches from the rear corners. From
there, mark the remaining locations for holes at 7-1/4” center to
center intervals.
Place a washer on the button head bolt and push through the
body mounting holes.
Put the VW square washer on the underside of the bolt and
apply the NYLOC nut.
Finger tighten bolts.
