It must be checked with the lift cylinder and both wing cylinders fully
retracted.
For snow plow light installation see separate instructions.
Orange wire on Harness (32) will attach to both orange wires of the “B”
harness supplied in the Light Module Kit. Reference Form 1-757
Route Cables “C” (Yellow) from module to Harness (32). Connect both “C”
Harness female ends to the male corresponding ends of the Harness (32).
Connect both male ends from the snow plow light to the female ends on
the Plow Side Harness (33).
Check snow plow light blinkers to make sure the wires have not been reversed.
Note: All electrical connections should have both ends coated with a
dielectric grease, Meyer Part No. 15632, prior to final installation. This will
ensure a good connection and help in preventing corrosion.
24. Refer to Operation and Maintenance Manual for complete controller operation.
25. After all electrical connections have been made the drop speed of the
plow may be evaluated / adjusted. To adjust, loosen the hex nut
and adjust in to slow the drop speed and out to make it faster. After ideal
drop speed it achieved, retighten the hex nut. See below.
V-70 Lower Adjustment:
Loosen jam nut and turn knob clockwise to slow the drop of the plow and counter
clockwise to speed the drop of the plow. Tighten jam nut.
After cycling of the plow, recheck oil level.
(7)
27. Assemble adjustable stacking stop bolts to lift frame (38) using
5/8-11 x 3” bolts (51), lockwasher (45) and jamnuts (52). See below.
Note: Adjustment must be made after moldboard assembly is installed.
Adjustment bolts (51) should make contact with the a-frame before any
part of the A-Frame or moldboard come in contact with the lift arm and,
or hydraulic unit while raising the snowplow or stacking snow. Moldboard
should be checked in all positions.
28. Attach Plow Markers (62) to moldboard using 5/16-18 x 1” Bolt (63), 5/16” Flatwasher
(65) and 5/16-18 Locknut (64).
26. Attach the Lift Chain to the Lift Arm (73) through the two hooks on the
lift arm. Adjust the lift chain at the lift arm so that there are 2-3 links of
slack. This ensures that the plow blade will lift fully and be able to follow
the ground contour while plowing.
75
76
87
88
89
71
54
58
61
80
81
36
70
60
57
55
78
79
82
83
84
85
64
63
62
53
55
56
57
57
59
60
37
60
20
22
77
71
58
61
54
84
85
81
80
87
77
76
75
78,79 & 86
82
83
88 & 89
