6
FIGURE 11
15. Place the motor assembly down into the hopper, inserting
the end of the spreader shaft into the impeller coupler.
Secure it with a 1/8" x 1-1/4" cotter pin, spreading the
ends of the pin around the coupler. See figure 9.
16. Fasten the motor mount bracket to the hopper using four
5/16" x 1" hex bolts, 5/16" flat washers, nylon washers
and 5/16" nylock nuts. See figure 9.
14. Assemble the impeller coupler onto the motor shaft and
secure it with the set screw against the flat side of the
motor shaft. See figure 8.
FIGURE 10
SET SCREW
IMPELLER
COUPLER
5/16" x 1"
HEX BOLT
NYLON
WASHER
5/16" NYLOCK NUT
MOTOR
ASSEMBLY
5/16" FLAT
WASHER
1/8" x 1-1/4"
COTTER PIN
SPREADER
SHAFT
FIGURE 8
10. Attach the spreader's mounting brackets to the vehicle's
rear rack using four 5/16" x 1-3/4" carriage bolts,
mounting clamps and plastic knobs. Use the adhesive
pads to protect the rack. See figure 6.
5/16" x 1-3/4"
CARRIAGE BOLT
MOUNTING
CLAMP
PLASTIC KNOB
MOUNTING
BRACKET
ADHESIVE PAD
IMPELLER
1/8" x 1-1/4"
COTTER PIN
1/8" HAIRPIN
AGITATOR
SPREADER
SHAFT
FIGURE 9
11. Insert the 1/8" hairpin agitator into the middle hole in
the spreader shaft. See figure 7.
12. Slide the end of the spreader shaft through the plastic
bushing in the bottom of the hopper. See figure 7.
13. Slide the impeller onto the spreader shaft and secure
it with a 1/8" x 1-1/4" cotter pin. See figure 7.
