5
If you are using extension brackets:
4. Attach the extension brackets to the legs of the spreader
frame. Use two 5/16" x 2" hex bolts and 5/16" nylock
nuts per bracket.
Tighten. See figure 4.
5/16" NYLOCK
NUT
MOUNTING
BRACKET, R.H.
5/16" x 2-3/4"
HEX BOLT
If you are using extension brackets:
5. Attach the R.H. mounting bracket to the extension bracket
shown in figure 5 using two 5/16" x 1" hex bolts and
5/16" nylock nuts.
Tighten. Repeat on the other frame
leg with the L.H. mounting bracket.
FIGURE 5
FIGURE 6
FIGURE 4
5/16" x 2"
HEX BOLT
EXTENSION
BRACKET
5/16" NYLOCK NUT
6.
Attach an angle stop bracket and a swivel bracket to
the rear hole in the R.H. shield bracket using a 1/4"
x 1" hex bolt, two 1/4" washers, a nylon washer and
a 1/4" Nylock nut. Place the angle stop bracket on
inside and swivel bracket on outside.
Tighten
locknut
so the swivel bracket can pivot freely. See figure 12.
Repeat step on L.H. shield bracket.
7.
Attach a swivel bracket to front hole in the R.H. shield
bracket using a 1/4" x 1" hex bolt, two 1/4" washers,
a nylon washer and a 1/4" Nylock nut.
Tighten
the
nut so that the swivel bracket can pivot freely. See
figure 12. Repeat step on L.H. shield bracket.
SWIVEL
BRACKET
ANGLE STOP
BRACKET
1/4" x 1"
HEX BOLT
1/4"
WASHER
1/4" NYLOCK
NUT
NYLON
WASHER
SHIELD
BRACKET
NYLON
WASHER
8.
Assemble spreader shield to the front swivel brackets
using two 1/4" x 3/4" carriage bolts, 1/4" washers and
the two 1/4" plastic knobs. See figure 13.
9.
Assemble spreader shield to the rear swivel brackets
using two 1/4" x 1" hex bolts, four 1/4" washers and
two 1/4" Nylock nuts.
Tighten
the nuts so that the
swivel bracket can still pivot freely. See figure 13.
FIGURE 7
1/4" x 1"
HEX BOLT
1/4" WASHER
1/4" NYLOCK NUT
PLASTIC
KNOB
1/4" x 3/4"
CARRIAGE BOLT
