Meyer Sound MPS-482HP, Operating Instructions Manual

Page: 22 / 32

APPENDIX B: ASSEMBLING LOUDSPEAKER CABLES
22
CAUTION: Screws should not be inserted into the Phoenix connector while the connector rests in a mating
plug. Doing so will damage the contacts. During assembly, the Phoenix connector should only be held in place
externally.
4. Repeat the previous steps and attach the other end of the cable to another Phoenix 5-pin female cable mount
connector.
5. Verify the wiring polarity is correct for both cable ends.
ASSEMBLING PHOENIX-TO-EN3 LOUDSPEAKER CABLES
When connecting loudspeakers equipped with EN-3 connectors to the MPS-482HP power supply, you need a Phoenix
5-pin female to EN3 5-pin female cable. The following procedure documents how to assemble this cable. If you are starting
with an EN3-to-pigtail cable, you can skip steps 4–7 in this procedure.
To assemble a Phoenix-to-EN3 cable:
1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding by 1 inch and then strip the
black, red, blue, and white wires by 0.275 inch.
2. Insert the five exposed conductors into the five cable holes in a Phoenix 5-pin female cable mount connector. Use the
following wiring scheme.
3. Secure the conductors by tightening the five screws in the Phoenix cable mount connector. Screws should be torqued
to 5–6 Nm (4.4–5.3 In-Lbs).
Assembled Phoenix-to-EN3 Cable
Pin Destinations for Phoenix 5-Pin Female Cable Mount Connector
!
1”
0.275”
screws
Pin 5 White Audio signal (+)
Pin 4 Blue Audio signal (-)
Pin 3 Shield drain Audio shield
Pin 2 Red DC power (+)
Pin 1 Black DC power (-)