Meyer Sound MPS-482HP, Operating Instructions Manual

Page: 24 / 32

APPENDIX B: ASSEMBLING LOUDSPEAKER CABLES
24
ASSEMBLING PHOENIX-TO-ECO-M LOUDSPEAKER CABLES
When connecting loudspeakers and power supplies equipped with combination of Phoenix and ECO-M connectors, you
need a Phoenix 5-pin female to ECO-M 7-pin female cable. The following procedure documents how to assemble this
cable.
To assemble a Phoenix-to-ECO-M cable:
1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding by 1 inch and then strip the
black, red, blue, and white wires by 0.275 inch.
2. Insert the five exposed conductors into the five cable holes in a Phoenix 5-pin male cable mount connector. Use the
following wiring scheme.
3. Secure the conductors by tightening the five screws in the Phoenix cable mount connector. Screws should be torqued
to 5–6 Nm (4.4–5.3 In-Lbs).
CAUTION: Screws should not be inserted into the Phoenix connector while the connector rests in a mating
plug. Doing so will damage the contacts. During assembly, the Phoenix connector should only be held in place
externally.
Assembled Phoenix-to-ECO-M Cable
Pin Destinations for Phoenix 5-Pin Male Cable Mount Connector
1”
0.275”
screws
Pin 5 White Audio signal (+)
Pin 4 Blue Audio signal (-)
Pin 3 Shield drain Audio shield
Pin 2 Red DC power (+)
Pin 1 Black DC power (-)
!