Stop ends
Fig. 32.1 Stop end bracket SB 110 on a horizontal Mammut XT panel
Support frame STB 450
Stop end bracket
Tie rod in mul-
ti-function profile
with flange nut
Clamping device to attach stop end bracket through support frame
Support frame STB 450
Stop end bracket
Description
Ref. No.
Stop end bracket SB 110 .......
29-406-40
Clamping device for stop end
bracket SB 110 .....................
29-406-60
Flange nut 100 .....................
29-900-20
Articulated flange nut 15/120
29-900-10
Tie rod DW 15/45 .................
29-900-76
The stop end bracket SB 110 can
be used for wall thicknesses up
to 90 cm. It has a sliding part
that is slid up against the existing
component at the stop end
(Fig. 32.1 and 32.2). The stop
end bracket is mounted by slid-
ing it horizontally between the
support frames (Fig. 32.4) and
by attaching a tie rod DW 15/45
and an flange nut 100 or an
articulated flange nut 15/120 to
the nuts of the multi-function
profiles of the panels (StarTec XT,
StarTec, Mammut XT, Mam-
mut 350 or Mammut). The
support frame is then located
between the panel and the stop
end bracket.
When installing the stop end
bracket, please observe the
following:
Æ
Mammut: When attach-
ing the stop end bracket to a
horizontal panel, make sure the
bottom of the panel faces the
side to which the sliding part of
the stop end bracket is attached
to form the stop end.
Æ
Mammut and StarTec: The
clamping device for the stop end
bracket SB 110 must be used
to attach the stop end bracket
(Fig. 32.2).
Sliding part
Sliding part
Fig. 32.2 Stop end bracket SB 110 on a horizontal Mammut/StarTec panel
with a clamping device for the stop end bracket
Flange
nut
Fig. 32.3
Fig. 32.4
STB-32
Technical Instruction Manual / Status November 2019
STB
Support frame
