MEV™ Daytona™ OWNERS MANUAL
20
Batteries contain high current. Do not overfill or allow water to stand on top of the batteries.
Doing so could result in personal injury and or property damage.
•
Use distilled water, do not use tap water
Add water only after charging unless the electrolyte level is below the top of the battery plates.
Add water to cover plates then check electrolyte levels again once charged.
Note: a battery watering gun or bottle is available at many auto parts dealers.
Inspect the wires and terminal connections for corrosion, fraying, or damage. Replace wires if
necessary. Ensure battery wire terminal connector nuts are tightened to 95-‐105 inch pounds –
always use a torque wrench and do not over tighten.
•
If the battery wires or terminals are damaged or corroded, they should be replaced or
cleaned. Failure to do so may cause them to overheat during operation.
•
Torque battery hold down straps to 40 in-‐lbs to ensure the batteries are held in place
securely.
•
After each use, the cart should be placed on charge. The batteries should never be left
discharged longer than absolutely necessary.
Battery Charging
•
Batteries emit hydrogen which is an explosive gas. While charging, keep cart in well
ventilated areas.
•
Do not cover the cart while charging as an accumulation of hydrogen gas could result in an
explosion.
WARNING
CAUTION
CAUTION
WARNING
