MEV™ Daytona™ OWNERS MANUAL
16
6. Adjust the tire/tyre pressure to the recommended levels – 30 psi / 2.75 bar.
7. Lubricate front and rear suspension lubrication points – the lubrication nipples can be found
on the suspension arms.
Returning Cart to Service
1. Fully charge the batteries.
2. Check battery electrolyte levels, add distilled water if necessary after charging.
3. Adjust the tire/tyre pressure to the recommended levels.
4. Perform Pre-‐operation Checklist (see page 15).
Maintenance:
•
Only a certified technician should repair the cart. It is important to abide by all procedures
described in this manual and all safety signs such as “Danger”, “Warning”, or “Caution”.
•
If a problem is found during routine maintenance or inspection, do not operate the cart until
the problem has been repaired.
•
Wear proper safety apparel while repairing the cart. Proper safety apparel includes but is not
limited to: safety goggles or approved eye protection, insulated gloves, and a face mask.
•
Remove all jewellery and loose apparel items.
•
Use insulated tools while working on any electrical components.
•
Set the key switch to OFF and the drive stick to Park (‘P’). Use chocks to secure the wheels.
•
Components such as the motor, controller, and resistor may become hot during operation.
To avoid burns, allow these components time to cool before a certified technician performs
service or inspects the cart.
WARNING
