www.mettatec.com
Operation requirements
For integration requires:
1. A
PPK Kit Phantom4
2. A Drone: Phantom 4 Pro v.1 / v.2 or Phantom 4 Advance (Not included)
3. An Emlid Reach M2 or M + with GNSS Antenna (Not included)
4. A RiNEX compatible GPS Base Receiver (Not included)
Image: Kit components.
Kit Components:
1.
Antenna support
with short connection cable and high resistance velcro
2.
M2 / M + Module
holder with power regulator, Micro-USB cable for power-up and
heavy duty 3M Velcro
3.
Photo Trigger Sensor
attached to the module support
Installation
1.
Glue one side of the velcro to the center back of the M2 / M + module.
2.
Connect the 6-pin connector of the M2 / M + bracket to the
S1
connector of the
M2 / M + module.
3.
Connect the 5-pin connector of the Photo Trigger Sensor to the
C1
connector of the
M2 / M + module.
4.
Using the velcro, firmly place the M2 / M + module on the Module Holder.
5.
Install the M2 / M + Bracket on the bottom of the left landing gear of the Drone,
using the two lugs on the crossbar. To do this, first insert one of them and then
slide the crossbar upwards, until the other handle can also be easily inserted.
6.
Plug the Micro-USB cable into the USB slot of the Drone.
7.
Remove the clear plastic Clip located at the end of the left front arm of the Drone.
