Metronic 450908, Installation Manual

Page: 22 / 28

M
Satellite validation
For each satellite, you have now to memorise the right
position in the motor. The operation is done for Hotbird and
Atlantic Bird 3, you have to do it for Astra, etc.
Example for Astra 19° E
• Go onto the Astra reference channel.
• Go into the DiSEqC 1.2
(2)
menu and give a number
(6)
to
Astra 19°E (03 if you hesitate).
• By a continuing rotation
(4)
and then a step by step
rotation
(5)
, make the motor spin to obtain the maximum
level and quality.
• Memorised
(7)
the founded position.
• Check that you receive the Astra channel. If it is not the
case, that means that you memorised another satellite,
which emit some channels at the same frequency. Try
the operation above again and make sure that your
satellite dish is pointed slightly on the left from Hotbird
like shown on the Diagram 17 underneath. Do the same
operations for the other satellites. For your information,
the diagram 17, gives you the satellites relative position
for which some channels are pre-programmed in the
metronic receivers. When you receive all the satellites,
screw definitively all the nuts. Your installation is finished.
Note: The Hispasat reception with a motorised installation
is very difficult and need a perfect alignment. For the
perfect reception of this satellite, we advise a fixed
installation, with a particular look at the adjusting of
the counter-polarization.
20
0 208 994 11 81
(2)(4)(5)(6)(7)
Go to corresponding
paragraph page 2 and 3