Metronic 441808, Instruction Manual

Page: 16 / 20

16
10 - Specifications
Problem Possible cause What to do
Standby light not lit Mains lead unplugged
Mains fuse blown Check mains lead
Check fuse
No signal found Aerial is disconnected
Aerial is damaged / misaligned Check aerial lead
Check aerial
Ensure that you are capable of
receiving Digital TV.
No picture or sound Tuned to digital teletext chan-
nel Switch to another channel
Scrambled channel message Channel is scrambled This Eco zapbox is not able to
decode scrambled channels
No response to remote control New batteries required Plug in and turn on switch at
mains
Forgotten PIN code Contact the helpline
You have moved your TV and
you find you are no longer able
to receive digital channels The aerial feed maybe sent
through a distribution system
which can / may reduce the
digital signal now received by
the Eco zapbox. Try a signal booster or a direct
feed from the aerial.
Tuner and channel • RF input connector
(IEC-TYPE, IEC169-2, female)
• RF output connector
(IEC-TYPE, IEC169-2, male)
• Frequency range:
470MHz ~862MHz (UHF)
Decoder
• Transport stream
• Profile level
• Input rate
• Video format
• Audio format
• Video output MPEG-2 ISO/IEC 13818
MAX. 15Mbit/s
MPEG-2 Main profile@Main level
4:3/16:9 Switchable
MPEG Layer I & II, 32 / 44.1 / 48KHz
RGB, CVBS
Connection
• Main power cable
• Tuner
• Video
• Audio
• Data port Fixed type
Antenna input
Composite video output, twin scart
Stereo audio output, digital coaxial audio output
RS-232 (for service use only)
Power supply
• Input voltage
• Power consumption AC 230V~50Hz
MAX. 8W/standby <1W
IMPORTANT: Due to continual revision and improvements to our products
design, specifications are subject to change without notice.