6
Audible Indicators
The scanner provides sounds to signal certain conditions. To change the
volume (three settings are available) or turn the beeper off, refer to the
Programming Guide section: Beeper Tones.
One Beep
When the scanner
first
receives power, diagnostic prompts
are displayed and then the scanner "beeps." After that, each
time the scanner
successfully
reads a bar code, it "beeps."
Razzberry
If, upon power up, the scanner emits a razzberry tone, then
Tone
the scanner has failed diagnostics.
Note:
The scanner can be programmed to emit a razzberry
tone when the timeout occurs during communica-
tion between the host and scanner. Refer to the
Programming Guide section: Audible Indicators for
Communication Timeouts.
Three Beeps
When the scanner enters the program mode, it beeps three
times then the message "PROGRAM MODE ENABLED"
appears. When the scanner exits the program mode, it beeps
three times and the message "READY TO SCAN"
reappears.
Note:
The scanner can be programmed to emit three beeps
when the timeout occurs during communication be-
tween the host and scanner. Refer to the Programm-
ing Guide section: Audible Indicators for Commun-
ication Timeouts.
