22
Appendix B
Default Settings
Many functions of the scanner can be "Programmed"-that is, enabled or disabled. The
factory programs the scanner to a set of default parameters (marked with an asterisk (*)
in the default column on the following pages). Unmarked parameters show the
unavailability for that protocol. To speak with the host system properly, program the
scanner to match the systems individual requirements. Notice that not all functions
support all communication protocols. If your protocol supports a function, a check mark
appears on the chart.
Note:
Although the Programming Guide mentions DTR input, Poll Light Pen 5
Volts and No Poll Light Pen, the IS4320-41 ScanKey scanner cannot support
these options.
Parameter
Default
RS-232
Light Pen
Enter Program Mode After Any Scan
*
T
T
Enter Program Mode Only on First
T
T
Scan
Short Range Activation
T
T
Long Range Activation
*
T
T
Normal Scan
*
T
T
Pulsing Scan
T
T
Custom Scan
T
T
Short Same Symbol Rescan
T
T
Long Same Symbol Rescan
*
T
T
Alternate Beeper Tone 1
T
T
Alternate Beeper Tone 2
*
T
T
Alternate Beeper Tone 3
T
T
No Beeper Tone
T
T
Two Second Time-out
T
No Two Second Time-out
*
T
Razzberry Tone on Time-out
T
No Tone on Time-out
*
T
Three Beeps on Time-out
T
Beep Before Transmit
*
T
Beep After Transmit
T
Baud Rate
9600
T
Parity
Space
T
8 Data Bits
T
