Metrologic IS1000 Series, Installation And User Manual

Page: 17 / 44

IS1000 – Installation and User’s Guide
11
4. SETTING UP
Proceed as follows to set up the IS1000:
•
Charge the laser reader battery
•
Connect the radio base to the host or terminal by a special cable corresponding to the type of
interface selected (the terminal must be turned off before connection)
•
Turn on the terminal
•
If necessary, connect the radio base to the mains power supply by its power supply unit
•
Set up the communication between the laser reader and radio base
•
Configure the communication mode
•
Configure the symbologies
4.1. Charging the Battery
Connect the laser reader to the charger as shown below (read window facing upwards).
Plug the power supply unit to the mains power supply.
The red charge LED (visible through the window) lights up and remains lit when charging.
The LED flashes when the charge is complete.
A full charge lasts approximately 3 hours.
Do not charge the laser reader after exposing it to very low or high temperatures.
It is recommended to charge the laser reader at an ambient temperature of between 0°C
and 45° C.
!
Recommendation: