￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Installation
916 Ti
‑
Touch
￭￭￭￭￭￭￭￭
19
2
Connect the Remote Box connection cable to an MSB connector
on the rear side of the Ti
‑
Touch.
3
Switch on the Ti
‑
Touch.
You can connect an 869 Compact Sample Changer. The Remote Box also
has an MSB socket at which a further MSB device, e.g. a dosing device,
can be connected.
You will find precise information concerning the pin assignment of the
interface on the Remote Box in the Appendix of the more detailed man-
ual.
5.6
Connecting USB devices
5.6.1
General
The 916 Ti
‑
Touch has a USB connector (Type A socket) for peripheral devi-
ces with USB interface and for Sample Processors. If you wish to connect
more than one device to the USB, you can use a commercially available
USB hub.
NOTICE
We recommend that the Ti
‑
Touch be switched off while you set up or
disconnect connections between the devices.
5.6.2
Connecting a USB hub
Use a USB hub with its own power supply.
Connect the USB hub as follows:
1
With the help of the 6.2151.030 cable (length 0.6 m) or the
6.2151.020 cable (length 1.8 m), connect the USB connector of the
Ti
‑
Touch (Type A) with the USB connector of the hub (Type B, see
manual for the USB hub).
The USB hub is recognized automatically.
5.6.3
Connecting a printer
Printers that are connected to the 916 Ti
‑
Touch must meet the following
requirements:
￭
Printer languages: HP-PCL, HP-PCL-GUI, Canon BJL Commands or
Epson ESC P/2
￭
Paper size: A4 or Letter.
