GB
- 16 -
a mild detergent to remove crumbs, dust, liquids,
etc.
• Let the appliance dry thoroughly before storing.
• Store the appliance in a dry environment at room
temperature.
• Keep the appliance out of reach of children.
6. Troubleshooting
Problem
Possible cause
Solution
The LED
display (12)
shows error
code “E01”.
Vacuum lid (1) is not
properly closed.
Close vacuum lid
(1). If error code
continues to show,
it is an electronics
problem. In this
case, please consult
customer service or a
qualified technician.
Appliance
does not turn
on.
Appliance is not
properly plugged into
a grounded outlet.
Plug appliance into
a grounded outlet.
Make sure to plug it
in tightly.
Power cord is
damaged.
Check the power
cord for tears and
frays. If damage is
confirmed, do not use
the appliance and
consult a qualified
technician.
ON/OFF button (7)
was not properly
pressed.
Press ON/OFF
button (7).
Appliance
does not pull
a complete
vacuum.
Vacuum/sealing
time is not set high
enough.
Set vacuum and
sealing times higher
and vacuum again.
Pouch is not placed
correctly across seal
bar (3) and/or within
vacuum chamber
(2).
Reposition the pouch.
Make sure the open
end of the pouch is
across the seal bar
(3) and inside the
vacuum chamber
(2) and there are no
wrinkles in the pouch
along the seal bar (3).
If sealing is incorrect,
cut off the seal and
make a new one.
If packaging from a
roll pouch, first seal
may be incomplete
or there are gaps in
one of the seals.
Make sure first seal
is complete and
there are no gaps
or wrinkles in either
seal. If sealing is
incorrect, cut off the
seal and make a new
one.
Appliance and
vacuum pouch are
not clean and dry.
Wipe the surface of
the seal bar (3) and
the upper inside part
of the pouch and try
again.
Problem
Possible cause
Solution
Vacuum pouch
loses vacuum
after being
sealed.
Seal is not correct.
Leaks along the seal
may be caused by
creases, crumbs,
grease or liquids.
Reopen the pouch
and clean its upper
inside part before
resealing.
Sharp edges of
items in vacuum
pouch punctured
small holes into
pouch.
Cover sharp edges
with paper towel and
vacuum in a new
pouch.
Fruits and
vegetables which
release gases if not
properly blanched
or frozen before
packaging were put
into vacuum pouch.
Open pouch. If you
think spoilage has
begun, discard
food. If food
spoilage has not yet
begun, consume
immediately. If in
doubt, discard food.
Appliance does
not seal vacuum
pouch properly.
Sealing time not
long enough.
Increase sealing time
and try again.
Moisture or food
particles are present in
the seal area.
Wipe the inside of
the pouch clean and
try again.
Pouch is not properly
placed along seal
bar (3).
Reposition the bag.
Make sure the open
end of the pouch is
across the seal bar
(3) and there are no
wrinkles in the pouch
along the seal bar (3).
If sealing is incorrect,
cut off the seal and
make a new one.
7. Disposal
Environmental Protection
Discarded electric appliances are
recyclable and should not be discarded
in the domestic waste! Please actively
support us in conserving resources and
protecting the environment by returning
this appliance to the collection centres.
Dispose of packaging in accordance to
applicable legal regulations.
Declaration of conformity
Hereby, we declare that this Chamber
Vacuum Sealer is in compliance with the
essential requirements and other relevant
provisions of Directive 2006/42/EC.
