Flo 1700 Series Mobile Computing Workstation Operations Manual, Doc. No. 400210 Rev H
25
InterMetro Industries Corporation
Flat Panel Display
The Flo1700 Series Mobile Computing Workstation comes typically with an LCD monitor. The
standard display is capable of displaying screen resolutions of up to 1280x1024 pixels.
In order to avoid damaging the monitor’s screen, do not press the screen with your fingers. A
soft, clean, lint-free cloth or a lens brush of camel hair should be used to clean the screen.
Never pour or spray any type of liquid onto the monitor.
Additional information about the operation of the monitor can be found in the operating manual
from the original manufacturer provided with the Mobile Computing Workstation. For additional
information, please contact InterMetro Customer Service.
Powering Up the
Monitor
The Flo 1700 Series Mobile Computing Workstation power supply must
be turned on first before turning on the monitor. The ON/OFF switch for
the monitor is located on the monitor and may be turned on or off as
required.
Adjusting
Monitor
Parameters
To adjust different parameters on the monitor like brightness, contrast,
color, etc., please refer to the monitor’s user manual, which is shipped
with the Mobile Computing Workstation.
Notice
: In order to increase the run-time of your Flo 1700 Series Mobile
Computing Workstation with one charge of the power supply
battery, the monitor’s brightness should not be set higher than
15%. Depending on the make of monitor, it is factory set from 0
to 15%. If, for any reason, the brightness is set to a higher
value, set it back to less than 15% for an increased run-time.
Adjusting the
Monitor Position
The monitor position can be adjusted in all three axes: tilt up or down,
swivel left to right, and rotate monitor face.
Flo 1700 Monitor Position Adjustment
