Flo 1700 Series Mobile Computing Workstation Operations Manual, Doc. No. 400210 Rev H
13
InterMetro Industries Corporation
Getting Started
Unpacking
The Flo 1700 Series Mobile Computing Workstation will arrive fully assembled and fully
functional at the customer’s site in a cardboard box. After cutting the strapping bands, lift the
top of the box over the Mobile Computing Workstation. In order to avoid any injury, two (2)
people shall lift the Mobile Computing Workstation from the padding blocks. The workstation
may weigh between 110 and 135 lbs depending on the configuration.
Inspection
After the Flo 1700 Series Mobile Computing Workstation has been unpacked, the user should
inspect the unit for any shipping damage. If there is any damage, please contact InterMetro
Customer Service immediately.
Power Supply Preparation
Before placing a Flo 1700 Series Mobile Computing Workstation into service, the Power Supply
battery may need to be connected and should be initially charged for a full 24 hours.
Important Notice
:
Please refer to the respective supplemental operations manual included with the Mobile
Computing Workstation for the Power Supply installed for requirements and details on
battery preparation and initial charging of the Power Supply.
To charge the battery, plug the coiled AC power cord into an AC outlet and put the
ON/Extended Storage Switch into the “ON” position (see “Turning on the Power Supply” below).
Notice
:
For further information on power supply charge times and on the charge indicator
lights of the Remote Fuel Gauge, please refer to the respective Power Supply
supplement.
Turning on the Power Supply
If so equipped, the Power Supply of the Flo 1700 Series Mobile Computing Workstation must be
turned on to power all the workstation equipment. The Power Supply is controlled by the
“ON/Extended Storage” Switch located on the Power Supply that is typically mounted on the
bottom of the workstation.
