5
16.
Locate the grommet on the driver side,
route “Controller to FL Wheel and Grille” and “Left Side to
Controller”
into this grommet. Connect to controller installed in dash.
17.
To remove the front grille, locate the (6) six plastic fasteners at the top of the grille, that are
located under the hood.
18.
Starting at one side of the grille, firmly pull out on the bottom edge to release it from the panel.
Continue this process across the entire lower edge until grille is free.
19.
Using “Controller to FL Wheel and Grille” cable, bring wire to front of the vehicle, route short wire
to rock light location at top of fender well. Using supplied hardware, carefully drill 3/8
”
hole to
pass connector through. Secure rock light to fender well. Continue routing wire behind headlight,
in front of radiator.
