K
NOWLEDGE IS
P
OWER
E
nhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
®
Metra recommends MECP
certified technicians
IMPORTANT
If you are having difficulties with the installation of this product,
please call our Tech Support line at 1-800-253-TECH. Before
doing so, look over the instructions a second time, and make
sure the installation was performed exactly as the instructions
are stated. Please have the vehicle apart and ready to perform
troubleshooting steps before calling.
The World’s best kits.
®
MetraOnline.com
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
REV. 4/30/18 INST99-7809B
I N S TA L L AT I O N I N S T R U C T I O N S
99-7809B
KIT PROGRAMMING
After all connections are made and before installing the radio assembly into the dash, you must program the kit.
1.
**** Before programming the climate controls, make sure all connections are made to the Metra climate controls and the
temperature sensor on the driver side dash trim is plugged in, failure to do so will cause the kit to not program properly. ****
2.
Start the vehicle.
3.
With the vehicle running, press and hold the rear defrost button until the display backlight starts to flash.
4.
Release the rear defrost.
5.
The display will continue to flash for up to 60 seconds, do nothing until it stops flashing.
6.
When the display stops flashing test the climate control functionality. If they work properly, continue with the dash assembly.
7.
If the climate controls do not function properly turn off the vehicle and check that all connections are secure. After all
connections are verified, try to program the kit once more while writing down the codes that flash on the display during the
process (this is important information you may need if you must call Technical Support).
**** Note:
Factory clock and cabin temperature display at the top of the dash will be lost. The new radio will have a clock on the
radio display, and the new Metra climate control display will show the temperature information.
Note:
Press and hold the “Dual” button for 5 seconds to switch the temp display between Fahrenheit and Celsius.
