1.800.221.0932
|
MetraOnline.com
6
INSTALACIÓN
MONTAJE FINAL
PROGRAMACIÓN
Attention!
For models with a 8-inch screen, update the interface via the Axxess Updater
available at axxessinterfaces.com. Select “8-inch screen” once prompted to. Instructions to
update the interface are available at the end of this instruction booklet.
With the key in the off position:
1.
Connect the 16-pin harness with stripped leads, and the 6520 harness, into the interface.
2.
Connect the factory “
White
” 4-pin harness removed in step 5 of Dash Disassembly to the
“
Black
” connector from the interface.
Note:
The display screen will not function without this connection.
3.
Connect the 6514 harness to the wiring harness in the vehicle.
4.
Connect the climate control harness from the vehicle to the 99-6514B radio trim panel. This is the
harness that was removed in step 4 of dash disassembly
.
5.
Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Metra recommends using the proper mating adapter from Metra.
Note:
If an ASWC-1 (sold separately) will be used, do not connect it until the interface is
programmed and fully functional.
1.
When the interface first boots up, the factory screen will go through a boot up sequence for
a few moments. Do not touch any controls during this process.
2.
Test all functions of the installation for proper operation, before reassembling the dash. For
amplified models, also refer to the “Audio Level Adjustment” section.
OPERACIÓN DE LA PANTALLA
1.
Asegure el ensamblaje de radio completado al tablero usando el hardware de fábrica.
2.
Vuelva a armarlo al revés de como lo desarmó usando el panel de moldura del radio 99-6514B.
1.
Radio button
– Show the current time
2.
Player button
– Not used in this application
3.
Climate button
– Takes you to the climate screen
4.
Setting
button
– Takes you to the setting screen
5.
More button
– Shows the outside temperature
and current time
6.
Screen Off
– Turns the display off
1
2
3
4
5
6
AJUSTE DEL NIVEL DE AUDIO
Para los modelos
con
amplificador de fábrica:
1.
Con el vehículo y el radio encendidos, aumente el volumen hasta 3/4 de su totalidad.
2.
Con un pequeño destornillador, ajuste el potenciómetro hacia la derecha para aumentar el
nivel de audio y hacia la izquierda para disminuir el nivel de audio.
3.
Una vez que haya llegado al nivel deseado, el ajuste del nivel de audio está completo.
