REV. 3/16/2018 INST95-6523
3
KIT ASSEMBLY
1.
Attach the (4)
panels clips
to the radio
trim panel. (Figure A)
2.
Break the small locating pin
from inside surface of each
radio bracket. (Figure B)
3.
Position the
radio mounting brackets
into the sub dash opening and secure
with the (2) Phillips screws removed in
disassembly. (Figure C)
4.
Attach the
radio brackets
to the
aftermarket radio using the screws
supplied with the radio or the supplied
(8) Phillips screws.
Note:
Screws must not protrude from
slot in
radio brackets
as interference
with
mounting bracket
will occur when
sliding radio into mounting brackets.
(Figure D)
5.
Locate the factory wiring harness in
the dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative battery
terminal and test the unit for proper
operation.
6.
Slide the aftermarket radio into the
radio opening between the
radio
mounting brackets
until it clips into the
opening. (Figure E)
7.
Snap the
radio trim panel
into
the opening around the aftermarket
radio to complete the installation.
(Figure C)
(Figure A)
(Figure B)
(Figure E)
(Figure D)
Remove pin
