Metos Teddy 5L, Installation And Operation Manual

Page: 14 / 22

14.12.2004 Rev. 2.0
Operation instructions
8
4.1.3 Attachment drive
The mixer is equipped with an attachment drive with variable speed, and with the possi-
bility of attaching the following equipment:
• Meat mincer Ø62 mm, supplied with meat tray, stamper and set of knives consist-
ing of blade and plate Ø4.5 mm.
• Vegetable cutter mounted with discs for shredding, grating and cube cutting.
For further information regarding accessories, please see the special sheets following the
accessories.
The mixer must always be disconnected before mounting or dismantling of the accessory.
Mounting the accessories:
• Assemble the accessory in question.
• Stop the mixer.
• Turn the cover plate C away from the
hole.
• When mounting the pre-mounted acces-
sory A, the shaft B is inserted into the at-
tachment drive D of the mixer.
• By turning the accessory until the pin E is
pointing towards the slot G a correct
clutch is obtained.
• The accessory is pushed as far into the at-
tachment drive D as possible. (The pin E must be in the slot G, then the shaft of the
accessory is in a correct clutch with the attachment drive).
• The accessory is fastened by turning the star handle H clockwise.
Dismantling of accessories
• Stop the mixer.
• Turn the star handle H counterclockwise until the locking screw is free of the hole
F.
• Take out the accessory of the attachment drive, dismantle and clean it.
Recommended speeds for attachment drive