10
|
15.12.2018
Metos Lämpöelementti, Värmeelement, Heating Element 700 W
Installation into Metos Miro chaffing dish
200X250 Rectangular
1. Type 1 is to take the water pan out of the stand and turn it upside down.(step 1). Then to insert the
fillister and slide the heating unit to the right place(middle is the best place)(step 2)
2. Type 2 : step 1 is to take the water pan out of the stand and turn it upside down. Insert the heating
board on the threaded studs. step 2 is to insert the heating board on the threaded studs.
CAUTION:
Never unplug the unit by pulling on the electrical cord!
Step 3 is to tighten with the hand nuts.
Please tighten the hand nuts only by hand!
Using the chaffing dish
1. Fill the water pan with hot water(50°to 60°C). Please note that the pans should not be immersed in
the water!
Check the water level and then. The pan must never be used without water!
2. Close the lid.
3. Plug in the cord of the electric heating unit. Then wait 30 to 40 minutes for the chafing dish to reach
the perfect temperature.
CAUTION: Never use the electric heating unit when it is not inserted in the water pan!
(NOTE: With electric heating units that have a power control the maximum power can be
progressively reduced if required.
Position<9>=maximum·Position<1>=minimum·Position<0>=off)
Disassembly
1. Unplug the cord.
2. Wait until the water pan and the electric heating unit have cooled down.
3. Take the water pan out of the stand and turn it upside down.
4. Unscrew hand nuts by hand.
5. Slide the heating unit out of the elongations and lift it off the threaded studs.
Transportation
Please always unplug the cord before you move your chafing dish or beverage dispenser!
