9
NS300XHD, NS350XHD & NS370XHD
–
Rev 01 06/17 MJ - MCE
Reassembling After Cleaning
After cleaning the knife, the rest of the slicer must also be fully cleaned and dry before reattaching
slicer parts and using the slicer
1.
Insert the knife scraper over pins and slide back into position (Figure A).
2.
Insert the centre plate spindle completely and
rotate clockwise to secure (Figure B).
(Figure A)
(Figure B)
3.
Insert the centre plate over the knife and ensure that the grooves are
flush with the grooves on the fence plate.
(Figure C)
4.
Insert the carriage (Figure D) and tighten the
bottom runner knob (Figure E).
(Figure D)
(Figure E)
5.
Check that the bottom runner moves freely from left to right (Figure F).
6.
Check that the indicator knob works correctly (Figure F
).
(Figure F)
Removing the Knife
1.
Switch off and unplug from mains.
2.
Unscrew the centre plate spindle (counter clockwise) and remove from the rear of the machine.
3.
Remove the centre plate.
4.
Fit the knife removing tool over the knife, and secure it by tightening the two knobs.
5.
Once the knife removing tool is secure loosen the four screws securing the knife to the pulley.
6.
Pull off the knife removing tool with the knife
ALWAYS REMOVE HOLDING THE KNOBS
.
7.
Proceed to clean machine.
8.
Place the knife removing tool and knife back onto the slicer and follow the above steps in
reverse.
