MetalMaster HG3208VR, Manual

Page: 15 / 24

QC11Y Hydraulic Guillotine Shear
13
7
、
Electric System of Machine
7.1
General introduction
：
The machine adopts the three-phase 415V power supply. 24V to A.C. control circuit; 27V and then 24V to D.C. Light power is AC 220V; output of the transformer is supplied to control circuit.The machine connects the ground safely. The electric components of the machine
are maily installed inside the electric box and control panel. Pls refer to our electric components list for introduction of these components.
7.2
Caution:
7.2.1 This machine is special tool, so users should arrange special operators.
The operators should read this operation manual very carefully and receive
training by our plant. Operators can run this machine only under approval of
our technicians by training. People without training can not run this machine
to avoid loss and hurt.
7.2.2 Operator should lock the SA1 key button and turn off the power switch
at the electric box when leaves . Make sure the machine is power off when
no operator.The machine should be grounded properly.
7.3 Electric principle print(refer to chart 5)
7.4 Electric components list (refer to table 2)