MetalMaster HG3208VR, Manual

Page: 12 / 24

QC11Y Hydraulic Guillotine Shear
10
will automatically repeat the action of single mode until that times are up or switch
is turned off . Anyway we do not encourage customers to use this mode as the
machine runs quickly and sometimes may hurt the plate or accident occurs.
5.5 Adjustment of cutting angle
Turn the switch to adjust mode, press the angle decrease or increase button to
decrease or increase cutting angle; after adjustment, turn the switch to cutting
mode.
5.6 Reset of cutting angle(oil compensation of the series oil circuit )
The cutting angle is set up to be 2 degree originally. After many times angle
adjustment, 2 degree maybe not obtainable, and in this situation the angle can be
recovered back to 2 degree. (This item also suits the oil compensation of the series
oil circuit). The procedure is as below: turn the switch to adjust mode, stamp the
foot switch , then push the angle increase button. When the knife beam moves
down to the dead point, hold on the button for a few seconds and then release the
angle increase button , then release the foot switch . After adjustment is finished,
turn the switch to cutting mode.
5.7 Oil filling
When the machine have been operated for a period of time, the return pressure may
be consumed a lot, in this situation the knife beam can not return to the dead point,
so we will have to fill the oil in this case. Oil filling procedures as below: turn the
button on the panel to adjust mode, push the oil filling button, the knife beam
moves down to the dead point, , adjust the overflow valve up to pressure around
14~16Mpa, the pressure will be displayed by pressure meter(17). When filling is
finished, turn the button on the panel to cutting mode.