Metallkraft PRM 30 F, Operating Instructions Manual

Page: 12 / 48

12 PRM F | Version 1.07 | EN
Transport, Packaging, Storage
General risks during internal transport
Devices may only be transported by authorized and qualified persons. Act re-
sponsibly during transport and always consider the consequences. Refrain
from daring and risky actions.
Gradients and descents (e.g. driveways, ramps and the like) are particularly
dangerous. If such passages are unavoidable, special caution is required.
Before starting the transport check the transport route for possible danger
points, unevenness and disturban-ces as well as for sufficient strength and
load capacity.
Danger points, unevenness and disturbance points must be inspected before
transport. The removal of danger spots, disturbances and unevenness at the
time of transport by other employees leads to considerable dangers.
Careful planning of internal transport is therefore essential.
Transport with a forklift / pallet truck:
For shipping, the machine is firmly mounted on a pallet so that it can be trans-
ported by forklift or pallet truck.
Transport by crane:
The machine can be set up with a crane in a suitable location. To do this, the
machine must be attached to the crane in accordance with the regulations
(Fig. 4). The attachment points on the machine are to be used.
Fig. 4: Transport ring bending machine
For transport, all rollers must be fixed and all covers must be attached to the
machine frame.
The machine must not be rocked during transport by crane.
WARNING: DANGER OF TIPPING
The device may be lifted unsecured by a maximum of 2cm.
Employees must be outside the danger zone, the reach of loads.
Warn employees and, if necessary, advise employees of the hazard.
DANGER!
Danger to life due to falling of the load!
Falling loads can cause serious injury or even death.
- Never step under suspended loads.
- Fix loads carefully.
- When leaving the workplace, lower the load.