9
®
CAT755 - NLFRENES - v1.1 - 10102013
EN
3 Assembly
Visually inspect all components for shipping damage. If any shipping damage is found, notify carrier at once.
Shipping damage is not covered by warranty. The carrier is responsible for all repair or replacement cost
resulting from damage in shipment.
• Main assembly
• Castors (4 pcs)
• Saddle
• Bolts, washers, nuts
• Legs (2 pcs)
1. Attach two legs (67) to the base (47) using bolts (39) and lock washers (69) washer (66).
2. Fit four castors (68) to the legs (67) using nuts (65) and washers (66).
3. Put the saddle (21) onto the top of the piston rod (22) and slip it down.
4 Before first use
1. Leave the jack for one hour to allow the oil to settle before purging the system.
Note
: Failure to allow sufficient time for the oil to settle could result in air remaining in the oil. In this
event, the jack will not purge completely first time and a second purge will be required.
2. Purge the hydraulic circuit to eliminate any air in the system by turning the release handle (02) to the right
and turning the air vent screw (19) counterclockwise by one turn then pumping the foot pedal (60) 15 to
20 times. Please tightening the air vent screw (19) clockwise after the exhaust .
3. Test the jack, unladen, by raising it to full height and then lowering it. Open the release handle (02) to the
right slowly to control the rate of descent.
5 Operating instructions
WARNING! Ensure that you read, understand and apply the safety instructions
and warnings before use. Failure to heed these instructions may result in property
damage and/or personal injury.
1. Roll the transmission jack into position and pump the foot pedal (60) until saddle (21) reaches desired
height.
Note
: Follow vehicle manufacturer’s recommended procedures for removing the load as outlined in
vehicle service manual or repair guide.
2. Carefully center load on the saddle. Ensure the load’s center of gravity is centered on the saddle and the
setup is stable and secure.
Note
: Before lowering load check to ensure all tools and personnel are clear and it is safe to lower the
load.
3. Slowly and carefully turn the release handle(02) to the right to lower the load to its lowest possible
position.
Note
: The speed of lowering is controlled by the release handle. The more the valve is opened the more
rapidly the jack descends. Ensure the decent is slow and controlled.
copyrighted
document
- all
rights
reserved
by
FBC
