Metabo TKHS 315 M, Operating Instructions Manual

Page: 11 / 20

ENGLISH
31
4. Tighten flange nuts.
Installing the table extension
A
Caution!
When installing the rear table exten-
sion, both panel and support struts
need to be held as long as they are
only bolted to one end.
1. Fasten extension panel (113) with
two bearing bolts (116) , two was-
hers (114) and two flange nuts
(115) to the two brackets as illustra-
ted.
If necessary, adjust the position of
the brackets to match the width of
the table extension – retighten the
bolted connection.
2. Attach each of the supports (119)
with one bearing bolt (120) , one
washer (117) and one flange nut
(118) to the table extension (see il-
lustration).
3. Tighten all bolted connections of the
table extension hand-tight using a
suitable tool.
3
Note:
The supports of the table extensions
can be fixed securely in place. Alterna-
tively, they can be installed in such way
that the table extension can swing
down.
Stationary support installation
1. Insert the offset ends of the sup-
ports into the slots of the short strut
at the rear of the saw and slide
them towards the outside.
2. Screw the supports with one hexa-
gon screw each (122) and a self-
locking hexagon nut (121) as shown
to the strut.
Support installation for folding down
of table extension
1. Screw one hexagon nut (124) and
one self-locking nut (123) into the
lower end of the supports.
2. Insert the lower ends of the sup-
ports into the slots of the short strut
at the rear of the saw and slide
them towards the outside (see illu-
stration).
Tightening the screwed connections

Check all screwed connections of
the saw. Tighten all screwed con-
nections hand-tight with a suitable
tool.
Observe the following when tighte-
ning the screws:
– The machine must stand firmly
and levelly after the screws have
been tightened.
– Adjusting the table extension: the
table extension's surface must be
parallel with and in the same pla-
ne as the top of the saw table.
Swinging the table extension down
1. Slide the lower ends of the supports
towards each other.
2. Lift supports out of the strut and
swing table extension down as illu-
strated.
Transport handle installation
Item Description Qty.
113 Plate, table rear
extension 1
114
117 Washer 8.4 4
115
118 Flange nut M8 4
116
120 Bearing screw
M8 x 35 4
119 Support 2
121
123 Hexagon nut, prevai-
ling torque-type M6 2
122
124 Hexagon screw
M6 x 16 2
109
110
111
112
113
115
116
114
120
118
119
117
121
122
Item Description Qty.
125 Transport handle 2
126 Hexagon head screw
M6 x 16 4
127 Washer 6.4 4
128 Flange nut M6 4
124
123