ENGLISH
en
9
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
- Lead from lead-based paints,
- Crystalline silica from bricks and cement and
other masonry products, and
- Arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic
particles.
This also applies to dust from other materials such
as some timber types (like oak or beech dust),
metals, asbestos. Other known diseases are e.g.
allergic reactions, respiratory diseases. Do not let
dust enter the body.
Observe the relevant guidelines and national
regulations for your material, staff, application and
place of application (e.g. occupational health and
safety regulations, disposal).
Collect the particles generated at the source, avoid
deposits in the surrounding area.
Use suitable accessories for special work. In this
way, fewer particles enter the environment in an
uncontrolled manner.
Use a suitable extraction unit.
Reduce dust exposure with the following measures:
- do not direct the escaping particles and the
exhaust air stream at yourself or nearby persons
or on dust deposits,
- use an extraction unit and/or air purifiers,
- ensure good ventilation of the workplace and keep
clean using a vacuum cleaner. Sweeping or
blowing stirs up dust.
- Vacuum or wash the protective clothing. Do not
blow, beat or brush.
See page 2.
1 Tool lock
2 SDS chuck
3 Additional handle
4 Depth stop
5 Metabo VibraTech (MVT)
6 Rotation selector switch
7 Trigger switch
8 Lock
9 Switch button (for changing the operating
mode)
10 Battery pack release button
11 LED light to illuminate the workplace
12 Capacity indicator button
13 Capacity and signal indicator
14 Battery pack *
* depending on model
6.1 Assembly of the additional handle
For safety reasons, always use the additional
handle supplied.
Open the clamping ring by turning the additional
handle (3) anticlockwise. Push the additional
handle onto the collar of the machine. Insert the
depth stop (4). Securely tighten the additional
handle at the angle required for the application.
6.2 Battery pack
Charge the battery pack (14) before use.
Recharge the battery pack if performance
diminishes.
The ideal storage temperature is between 10°C and
30°C.
Li-Ion battery packs “Li-Power, LiHD“
have a
capacity and signal indicator (13):
- Press the button (12); the LEDs indicate the
charge level.
- The battery pack is almost flat and must be
recharged if one LED is flashing.
6.3 Removing and inserting the battery pack
Removing:
Press the battery pack release (10) button and
remove the battery pack (14).
Inserting:
Slide in the battery pack (14) until it engages.
7.1 Depth Stop Setting
Loosen the additional handle (3). Set depth stop (4)
to the desired drilling depth and retighten additional
handle. (3)
7.2 Switching On and Off
Press the trigger switch (7) to switch on the
machine. The speed can be changed by depressing
the switch.
To switch off release the trigger switch (7).
7.3 Operating mode selection
Press (8) the lock and turn the thumbwheel (9).
Drilling
Hammer drilling
7.4 Selecting the direction of rotation
Do not activate the direction switch (6) unless
the motor has completely stopped.
Select direction of rotation:
R = clockwise rotation (for drilling, hammer
drilling, drive in screws)
5. Overview
6. Initial Operation
7. Use