9
ENGLISH
Read instructions.
Wear hearing protection.
Wear safety goggles.
4.1
Before initial operation
•
Install the plug nipple.
4.2
Using the Tool
A
Caution!
To ensure a long service life of this
tool, it needs to be supplied with suf-
ficient quantities of pneumatic oil.
This can be achieved by:
−
a service unit with oiler at the
compressor.
−
a lubricator, installed directly on
the air tool or in the air line.
−
adding approx. 3-5 drops of pneu-
matic oil by hand every 15 minuts
of use (constant operation) to the
air inlet.
1.
Put socket on the drive.
2.
Set direction of rotation with the
reversing knob:
−
Reversing knob to the right:
right-handed rotation/driving
−
Reversing knob to the left:
left-handed rotation/unscrewing
3.
Setting the torque at the reversing
knob:
−
Reversing knob fully to the right =
maximum driving torque.
−
Reversing knob fully to the left
= maximum unscrewing torque.
−
Reversing knob gradually out-
ward = torque increases.
−
Reversing gradually to the centre
= torque decreases.
4.
Set the working pressure at the
compressor (refer to the technical
specifications for max. permissible
working pressure).
5.
Connect quick coupler to the air
supply.
6.
Pull trigger to start.
A
Danger!
Always disconnect from air supply
before servicing.
Repair and maintenance work other
than described in this section must
be carried out by qualified specialists
only.
•
Check all screwed connections for
tightness, tighten if necessary.
•
When the tool is not lubricated by a
service unit or line oiler, manually
add 3 - 5 drops of pneumatic oil for
every 15 minutes of operation (con-
tinuous operation) into the air inlet.
•
Do not store tool unprotected out-
doors or in humid environment.
•
Pneumatic oil 0.5 litre
Special lubricant for air tools, serv-
ice units and line oilers.
Stock-no. 090 100 8540
•
Line oiler R3/8" female
For fitting directly to air tools. Oil
level can always be checked
through sight glass.
Stock-no. 090 105 4592
A
Danger!
Repairs to air tools must be carried
out by qualified specialist ONLY!
Air tools in need of repair can be send to
the service centre in your country. See
Spare Parts List for address.
Please attach a description of the fault to
the power tool.
The tool's packaging can be 100 % recy-
cled.
Worn out machines and accessories
contain considerable amounts of valua-
ble raw and plastic materials, which can
be recycled.
These instructions are printed on paper
produced with elemental chlorine free
bleaching process.
4.
Operation
5.
Care and maintenance
6.
Available Accessories
7.
Repairs
8.
Environmental protection
