14
DEFCOM 3.1B
User Manual
The alarm system is usually supplied with 2 remote controls.
To add or remove remote controls from the memory, gather all the remote controls together
that are to be included in the alarm system’s memory and proceed as follows:
1. Disarm the alarm system and turn the ignition key ON for 3 times within 3 sec and keep it
ON the last time (a BEEP sound confi rms selection)
2. Turn the ignition key OFF within 10 sec and insert the
‘OVERRIDE’ CODE
.
3. When the last digit is confi rmed a series of BEEP–BEEP-BOOP-BOOP sounds confi rms the
code was correct and LED start fl ashing very fast.
4. Within 60 seconds press simultaneously the 2 buttons on the fi rst radio remote control;
one BEEP sound and the LED turns OFF for 2 seconds to confi rms pairing. Repeat the ope-
ration for all of the other radio remote controls to be paired, each time checking that they
have been stored successfully (any remote controls that are not paired during this phase
will be excluded).
5. To complete the pairing phase turn the ignition key ON or wait 60 seconds, a series of
BEEP–BEEP-BOOP-BOOP sounds confi rms the end of the procedure and the LED turns OFF.
15. ADDITIONAL REMOTE CONTROLS
For this kind of functioning its necessary pair the
CARD B9.5
optional, with them is possible
arming and disarming the alarm system without press the remote control buttons, and Mycro
remote controls stays operative; after paired the CARD using the
PRG007 V3 PROGRAMMER
to activate the
CARD B9.5
press it’s button 5 times.
Alarm system activation in the passive arming mode selected:
It occurs by moving the
CARD B9.5
away from the vehicle with the instrument panel OFF,
after 15 sec. of missing signal from the
CARD B9.5
the alarm system arms itself and will be
signaled as described in paragraph 1.
Alarm system disarming:
It occurs turning ON the instrument panel with
CARD B9.5
close to vehicle, disarming will be
signaled as described in paragraph 1.
If the
CARD B9.5
is still close to vehicle at the end of the initial immunity phase all the protec-
tions will be activate only after 15 seconds of missing signal from the
CARD B9.5
.
USE OF THE CARD B9.5 BUTTON
Alarm system arming:
when the button is used to arm the system pressing the
CARD B9.5
button all the protections will be included, the alarm system arming immediately and the
protections will be active after 26 second of immunity time if the
CARD B9.5
will not be close
to vehicle. If the
CARD B9.5
is still close to vehicle at the end of the initial immunity phase all
the protections will be activate only after 15 seconds of missing signal from the
CARD B9.5
.
Alarm system disarming:
when the button is used to disarm
the system pressing the
CARD B9.5
button the disarming will
be few seconds after pressing the button and the next passive
arming will be after 50 seconds instead of 15 seconds.
16. KEYLESS MODE BY CARD B9.5
MetaSystem Code:
ABS16900
