9
DEFCOM 3.1B
User Manual
EN
CENTRAL UNIT STATUS
LED
DIRECTION
INDICATORS
SIREN
Passive arming
Slow fl ashing
1 Short fl ash
1 BEEP
Arming by remote control
Slow fl ashing
2 Flashes
2 BEEP
Arming without internal tilt sensor
Slow fl ashing
Flashes 2 + 1
2 BEEP
+ 1 BEEP
Arming with active contact
Slow fl ashing
2 Flashes
2 BEEP
+ 1 BOOP
Initial immunity phase
Fast fl ashing
Testing during the initial
immunity phase
Fast fl ashing
1 BEEP
Central unit armed
Slow fl ashing
Alarm cycle
Switches off
Flashing
Sounds
Disarming without alarms
Switches off 1
Flash
1 BEEP
Disarming when the
motorcycle’s battery is fl at
Switches off 4
BEEP
Disarming when alarms
have been memorised
Switches off briefl y
every 6 sec.
1 BEEP
+ 1 BOOP
Pre-alarm phase
Switches off 5
BEEP
Service Mode
Flashing very fast
with ignition key ON
1. NOTIFICATIONS
If various alarms have been triggered, the memory will signal them in a sequence with 3 seconds pauses
and will repeat the sequence every 6 seconds. The memory is reset when the motorcycle is started up
or when the alarm system is armed with the remote control again.
NOTE:
Using the
CARD B9.5
with
KeyLess mode, the alarms memory stay available for one minute also after instrument panel activation.
MEMORISED ALARMS
LED SIGNALS
Internal movement sensor
1 Flash
Contacts 2
Flashes
Ignition key sensing
3 Flashes
Tampering with cables or battery
4 Flashes
The
DEFCOM 3.1B
alarm provides diff erent signals (led, siren and fl ashing of the vehicle indicators)
according to the diff erent commands received from remote control and diff erent conditions which it
is, following are reported the main signals. Some acoustic signals from the siren during arming and
disarming the alarm (highlighted in bold) will be emitted only enabling the
Buzzer Function
, this is
possible changing the product factory set-up during installation (see the paragraph
“12. MAIN PRO-
GRAMMABLE FUNCTIONS”
).
BUTTON A
BUTTON B
Dear Customer,
the
DEFCOM 3.1B
alarm has a set-up that allows it to be installed on your vehicle quickly and in
compliance with current regulations, at 12th paragraph of this manual are indicated the possible
operating options and if you desire change the original set-up, you could request the customization
to your installer. The product has been designed for Keyless activation and deactivation pairing the
optional
CARD B9.5
that you can require to your installer, the operations in Keyless mode are descri-
bed at 16th paragraph of this manual.
USER MANUAL
