Page 22
AEROCET-380 Operation Manual Rev A
7
WiFi Configuration and Setup
The WiFi on the AEROCET-380 will need to be connected to the local network where it is
used. This section covers the initial setup and configuration of the WiFi. Valid credentials for
a WiFi network in range and either a computer or smartphone that can connect to that
network must be used to configure the AEROCET-380.
1. After powering on the AEROCET-380, the WiFi interface will generate a local network
that allows the user to connect to it and configure the connection.
2. On a WiFi enabled computer or smartphone search for an open WiFi network that
starts with “ESP_” and connect to the network.
3. On the connected device open a web browser and go to IP address 192.168.4.1
Figure 7-1 - Web browser with IP address
4. Navigate to the WiFi Sta
tion tab and click “Switch to STA+AP Mode” so that the
AEROCET-380 can scan for networks in the area.
Figure 7-2 WiFi Station tab
5. Choose a WiFi network, enter the password, and click connect.
