34
Motion Configuration
There are 3 MD (Motion Detection) areas that can be enabled. Each MD can be individually enabled/disabled,
defined the covering range and trigger sensitivity.
To enable and verify the MD, follow the steps provided below:
1. Check the box to enable the motion area
2. Drag and drop to move the motion window
3. Hold and drag any corner of the rectangle to resize the window.
4. By dragging the pin of the slider bars, adjust the detection
“Sensitivity” and “Object Size” of the
rectangle covered area.
NOTE:
By
name implying, the “
Sensitivity
” setting means the sensitivity level to the motion detection; the
higher value given makes the motion window more sensitive to the moving object. “
Object Size
”
indicates the trigger threshold. A lower “Object Size” value means it is easier to exceed the value, and
thus trigger the motion event.
5. The status chart shows the motion activities. When the motion vector exceeds a threshold (the Object
Size), the motion trigger is activated.
6. To enable other motion area, repeat above steps.
7.
Click on “Apply” button to save the settings.
