Swing Arm Pin Fastener Replacement Kit
B.
IMPORTANT! PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE BEGINNING ASSEMBLY.
• Place all parts from the box in a cleared area and position them on the floor in front of you.
• Remove all packing material from your area and place them back into the box.
• Do not dispose of the packing materials until assembly is completed.
• To prevent unsafe or improper use, please read each step carefully before beginning.
•
It is recommended you replace one side at a time.
• Do not tighten hardware until both sides have been replaced. Keep all parts until the replacement is complete.
New Hardware Included:
A. SPX Max Swing Arm Pin Fastener,
QTY
-2
or
V2 Max Pro-Rehab
Swing Arm Pin Fastener,
QTY
-2
Each Swing Arm Pin Fastener comes with a
pre-set Plastic Shim and is marked with a blue tip
B. Socket Head Bolt, 5/16"x 1/2",
QTY
-2
A.
StEP 3
StEP 4
StEP 1
StEP 2
Adjuster Bar
As shown on the SPX Max
To Disassemble
Replacement Instructions
1. To prepare, remove the Gearbar and place the Footbar
Assembly in the highest position. In a counter-clockwise
direction, remove the Socket Head Bolt (G) and Washer (F)
from the Swing Arm Pin Fastener with the 1/4" Hex Key.
To prevent it from spinning, secure the flat ends of the Swing
Arm Pin Fastener with the 3/4" Open Ended Wrench as shown
in [FIG A]. Set aside Washer (F) to be reattached later. Socket
Head Bolt (G) to be replaced with new Socket Head Bolt (B)
supplied. Keep Swing Arm Assembly on the other side of
Reformer intact.
2.
Remove the Socket Head Bolt (G) from the Adjuster Bar using
the 1/4" Hex Key. Set Bolt aside to reattach later.
3. While holding on to the Long Arm of the Swing Arm
Assembly, remove the Socket Head Bolts (H) from the Footbar
using the 3/16" Hex Key. Set aside Bolts to reattach later.
4. Gently remove the full Swing Arm Assembly and set aside
to reattach later.
(F)
(G)
(G)
(H)
(E)
Existing Hardware to Retain:
C. Hex Lock Nut 3/8",
QTY
-2
D. Metal Flat Washer 3/8",
QTY
-8
E. Nylon Washer 1",
QTY
-2
F. Metal Flat Washer 5/16",
QTY
-2
G. Socket Head Bolt, 5/16"x 1",
QTY
-2
H. Socket Head Bolt, 3/16"x 1",
QTY
-4
REQUIRED TOOLS
INCLUDED
1/4"
hex
key
3/16"
hex
key
5/16"
hex
key
3/4"
spx
max
or
v
2
max
pro
-
rehab
open
ended
wrench
9/16"
socket
with
handle
push
tool
NOT
INCLUDED:
rubber
mallet
or
hammer
Long Swing Arm
Short Swing Arm
FIG. A
H.
C.
E.
D.
F.
G.
