18
A. Door within a door connection
Disconnect opener from power!
Remove cover. Locate auxiliary terminal block (TB1) on the control board. Remove jumper from termi-
nal leads 1 and 2 (not shown). Replace with contact switch leads as shown.
B. Coaxial antenna adaptor
A coaxial antenna connection can be used if the transmitter range is too short.
SPECIAL FEATURES OF THE MT5580P
A
B
TB1
24V
+
-
INSTALLING YOUR CM128 WIRELESS WALL BUTTON
INSTALL:
Carefully pry open the CM128 and locate the two screw for mounting.
To attach to the wall, use the two screws and wall anchors provided, if mount
to plaster wall (If using a recessed wall box do not use anchors).
NOTE: Tightening the wall mount screws will reduce clearance
between bracket and wall.
NOTE: Your CM128 Wireless wall button should be pre-programmed
into your opener, you should only need to program additional units.
Program CM128 Wireless wall button using the orange “LEARN”
Button:
1. Press and hold the button that you wish to operate your garage door.
2. Press and release the orange “learn” button on opener. The learn indicator light will flash continually.
3. Release the button when the opener light blinks. It has learned the code. Where no light is installed two clicks will be
heard.
+
+
+
Activate the opener only when door is in full view, free of obstruction and properly adjusted.
No one should enter or leave garage while door is in motion. Do not allow children to operate push
button(s) or transmitter(s). Do not allow children to play near the door.
Locate minimum 1.5m above the floor.
29
30
