IMPORTANT
NOTE
• BEFORE attempting to install, operate or maintain the operator, you must read
and fully understand this manual and follow all safety instructions.
• DO NOT attempt repair or service of your gate operator unless you are an
Authorized Service Technician.
When you see these Safety Symbols and Signal Words on the following pages, they
will alert you to the possibility of
Serious Injury or Death
if you do
not comply with the warnings that accompany them. The hazard may come from
something mechanical or from electric shock. Read the warnings carefully.
When you see this Signal Word on the following pages, it will alert you to the
possibility of damage to your gate and/or the gate operator if you do not comply
with the cautionary statements that accompany it. Read them carefully.
MECHANICAL
ELECTRICAL
SAFETY
» SAFETY SYMBOL AND SIGNAL WORD REVIEW
TABLE
OF CONTENTS
SAFETY 1-6
Safety Symbol and Signal Word Review
1
Installation Classifications
2
Safety Installation Information
3
Gate Construction Information
4
Important Safety Information
5-6
INTRODUCTION 7-8
Operator Specifications
7
Carton Inventory
7
Additional Items Needed for Installation
8
Wiring Specifications and Tools Needed
8
INSTALLATION 9-19
Overview of Typical Installation
9-10
Check Your Gate
11
Mounting Options
11
Manual Release
12
Determine Position of the Pull-to-Open Bracket
12
Assemble Gate Post Bracket (Pull-to-Open)
13
Attach Brackets to Gate Operator
13
Determine Mounting Location
14
Measuring and Marking for the Gate Bracket
14
Position Gate Operator on Gate
15
Test Gate Travel
16
Secure Post Bracket to Gate Post
16
Secure Gate Bracket to Gate
17
Warning Sign Placement
17
Standard Control Box
18-19
WIRING 20-25
Connect the Gate Operator (Gate 1) to the Control Box
20
Set the Bipart Delay (Model MGL400-24S Only)
21
Connect the Gate Operator (Gate 2) to the Control Box (Model MGL400-24S Only)
22
Junction Box (Model MGL400-24S Only)
23-24
Earth Ground Rod Installation (Optional)
25
Connect Batteries
25
ADJUSTMENT 26-30
Set DIP Switch
26
Limits 27-29
Force Adjustment
30
Timer-to-Close 30
PROGRAMMING 31
Remote Controls
31
Keyless Entry
31
Erase All Codes
31
Test 31
ADDITIONAL FEATURES
32-35
Control Inputs
32
Loop Inputs
33
Photo/Edge Inputs (P 6-7-8 and 9)
33
Safety Accessories for Secondary Entrapment Protection
34
OPERATION AND MAINTENANCE
36-37
Reset Button
36
Remote Control
36
Maintenance 37
Manual Release
37
TROUBLESHOOTING 38-41
Basic Control Board Layout
38
Wiring Diagram
39
Diagnostic Codes
39
Troubleshooting Chart and Tips
40-41
REPAIR PARTS
42-43
Control Box
42
Gate Operator Arm
42
ACCESSORIES 43
WARRANTY POLICY
44
TEMPLATE
BACK COVER
1