14
INSTALLATION
» DETERMINE MOUNTING LO MEASURING AND MARKING FOR THE GATE BRACKET
Center of Gate Hinge
PULL-TO-OPEN INSTALLATION
Gate Post
Closed Gate
7-3/4"
(19.7 cm)
7-3/4"
(19.7 cm)
NOTE: You may want to drive a stake in
the ground to help locate this point.
Bracket must
be straight
90°
Center of Gate Hinge
PULL-TO-OPEN INSTALLATION
Gate Post
Closed Gate
7-3/4"
(19.7 cm)
7-3/4"
(19.7 cm)
NOTE: You may want to drive a stake in
the ground to help locate this point.
Bracket must
be straight
90°
DETERMINE MOUNTING LOCATION
The gate post bracket assembly can be mounted at several places on the gate post.
Refer to the illustrations on page 11 for the ideal mounting location.
Refer to the illustrations to determine the appropriate dimensions for the
Pull-to-Open bracket.
NOTE:
It may be necessary to add shims (angle iron,
sheets of metal or wood) to the gate post to achieve the
required dimensions.
Gate Post
Gate Hinge Point
7" (18 cm)
Operator
Hinge
Point
7" (18 cm)
Gate Post
Gate Hinge Point
7" (18 cm)
Operator
Hinge Point
7" (18 cm)
Gate Post
Gate Hinge Point
7" (18 cm)
Operator
Hinge Point
7" (18 cm)
Gate Post
Gate Hinge Point
7" (18 cm)
Operator
Hinge Point
7" (18 cm)
Gate Post
Gate Hinge Point
7" (18 cm)
Operator
Hinge Point
7" (18 cm)
Gate Post
Gate Hinge Point
7" (18 cm)
Operator
Hinge Point
7" (18 cm)
X
X
X
Close the gate.
Close the gate.
Place the template (provided on the back page of this manual) under the center
of the gate hinge point.
Place the measuring tape under the center of the gate hinge point and measure
out 18 cm.
Use a screwdriver or dowel rod to temporarily mark the location in front of the
gate post.
Use a screwdriver or dowel rod to temporarily mark the location of the first
measurement.
1
1
2
2
3
3
4
5
MEASURING AND MARKING FOR THE
GATE BRACKET
Before proceeding, begin with the gate in the fully closed position. There are two
methods for determining the proper location of the post brackets:
• Paper template (Located on the back page of this manual. Must be cut out.)
• Tape measure.
Either method will work depending on preference.
TEMPLATE METHOD
TAPE MEASURE METHOD
Measure 18 cm from the previous mark.
Use the screwdriver or dowel rod to mark the location of the second
measurement.
Gate Post
Gate
Gate Post
TOP VIEW
TOP VIEW
1
2
1
2
3
Gate Hinge Point
Gate Hinge Point
7" (18 cm)
7" (18 cm)
X
X
X
Gate
3
5
4
