COPYRIGHT © 2008 MERIT ENTERTAINMENT
SCREW
SECURING
HARD DRIVE
MOUNTING
PLATE
FIGURE 3- ELITE WITH REAR DOOR OPEN
3 MEGATOUCH FORCE 2009 EDITION PM0513-13
Force Elite Games
Hard Drive Removal
1.
If you are connected to TournaMAXX
or TournaCHAMP, you must perform an
Update From Server
before remov-
ing the hard drive so that no informa-
tion is deleted.
2.
Turn off and unplug the game.
3.
Unlock and open the rear door.
4.
Remove the screw securing the hard
drive mounting plate (see Figure 3) and
slide the hard drive assembly towards
the back of the unit.
5.
Lift the hard drive assembly out of the
game until you’re able to disconnect the
4-pin power connector and the hard
drive ribbon cable from the rear of the
hard drive.
6.
Remove the 4 screws and shoulder
washers fastening the hard drive to
the mounting plate.
Hard Drive Installation
7.
Fasten the new hard drive assembly
to the existing mounting plate with the
4 screws and shoulder washers. See
Figure 1.
8.
Connect the 4-pin power connector in
the game to the mating 4-pin connector
attached to the hard drive adapter. See
Figure 1.
9.
Carefully reconnect the ribbon cable in
the game to the new hard drive as
shown in Figure 1. The red stripe on
the cable should be on the opposite
side as the power connector. You may
need to create extra slack in the cable
in order to connect it.
10. Slide the hard drive assembly into the
game and fasten it with the mounting
screw.
11. Continue with
Security Key Installa-
tion
if you are installing a security key.
12. Close and lock the rear door.
13. Restore power to the game. The game
will reboot twice to configure the hard-
ware. When prompted, perform a
touchscreen calibration.
14. If you are connected to TournaMAXX
or TournaCHAMP, you must re-enter the
dial-in settings, make the initial call into
the server and then perform two
Up-
dates From Server
. Refer to the
MegaNet® manual for information.
